Todd Dice (Customer) asked a question.

April 24, 2024 at 10:54 PM
Please consider adding stem run tees to your pneumatic fitting offerings

Please consider adding stem run tees in - at minimum - sizes 1/4, 3/8 and 1/2" tubing as shown in the image. Thank youPSJ-Frac-300x300

  • 3 answers
  • 203 views

  • Adisharr (Customer)

    Interesting - we stopped using these a few years back because they always seemed to pop out over time.

    • Todd Dice (Customer)

      Huh , never experienced that. Here's an image of how I use them with Nitra air prep but the fittings on the output are Norgren.

       

      IMG_0524

  • ADC Community_04 (AutomationDirect)

    Thank you for the suggestion. Your request has been sent to the product group for consideration.

 

Did this information resolve your issue?